| Overview | Package | Class | Deprecated | Help |
| Properties | |
|---|---|
| activeHoldDelay |
Specifies the amount of time in 100 of milliseconds to hold the active state before going
into the standby state when a local MC-LAG SAP goes down.
This parameter causes the node to delay sending the change in the T-LDP status bits
for the VLL endpoint when the MC-LAG transitions the LAG subgroup which hosts the SAP
for this VLL endpoint from "Active" to "Standby" or when any object in the endpoint,
i.e., SAP, ICB, or regular spoke-sdp, transitions from Up to Down operational state.
By default, when the MC-LAG transitioned the LAG subgroup which hosts
the SAP for this VLL endpoint from "Active" to "Standby",
the node sends immediately new T-LDP status bits indicating the new value of "Standby"
over the spoke-sdp's which are on the mate endpoint of the VLL.
The same when any object in the endpoint changes operational state from UP to Down.
There is no delay applied to the VLL endpoint status bit advertisement when
the MC-LAG transitions the LAG subgroup which hosts the SAP from "Standby" to "Active"
or when any object in the endpoint transitions to an operational UP state.
Default: 0. A value of zero means that when the MC-LAG transitioned the LAG subgroup which
hosts the SAP for this VLL endpoint from "Active" to "Standby",
the node sends immediately new T-LDP status bits indicating the new value of "Standby"
over the spoke-sdp's which are on the mate endpoint of the VLL.
The same when any object in the endpoint changes operational state from UP to Down.
type=int default=0 minimum=0 maximum=60 units=deciseconds Displayed(tab/group)=Active Hold Delay |
| activeMultipath |
When aluExtSvcEndPointModeActiveMultipath is set to true,
Tx are enabled for all endpoint objects. This only applicable when
svcEndPointTxActiveType is sdpBind for CPIPE service.
type=boolean default=false Displayed(tab/group)=Active Multipath |
| creationOrigin |
type=svt.L2RouteOriginType access=read-create default=manual |
| enableStandbySignaling |
Specifies whether PW standby bit will be sent to T-LDP peer
whenever spoke-SDPs of this endpoint are selected as standby.
type=boolean default=false Displayed(tab/group)=Enable PW Standby Signaling Master |
| enableStandbySignalingSlave |
Specifies whether transmission of any spoke in the endpoint will be blocked
when the spoke receives standby status notification from its peer.
type=boolean default=false Displayed(tab/group)=Enable PW Standby Signaling Slave |
| templateVersionPointer |
Pointer to the template if this object was created from a template.
type=Pointer default= Displayed(tab/group)=Associated Template (Template/Associated Template) |
| Properties inherited from ManagedObject |
|---|
| actionMask, children-Set, deploymentState, isFaultSquelched, name, objectFullName, selfAlarmed |