| Overview | Package | Class | Deprecated | Help |
| Properties | |
|---|---|
| assurance |
type=sas.TestAdminState access=read-only default=disabled |
| maxHistoryRows |
>
The maximum number of rows allowed in the node's
probe result table. The node will remove the oldest entry
in the table to allow the addition of a new history
row.
A value of 0 for this object disables creation of
tmnxOamPingHistoryTable entries.
DEPRECATED: 8.0 R5 - OBSOLETE: Never Supported type=long default=50 minimum=0 maximum=99000000 units=rows |
| packetFailureThreshold |
The Packet Failure Threshold parameter specifies the number
of times a probe can fail before the test fails.
The parameter has no effect if the value is higher than the
parameter value. The range is 0 to 15. The default is 1.
type=int default=1 minimum=0 maximum=15 Displayed(tab/group)=Probe Failure Threshold (Results Configuration) |
| packetInterval |
Specifies the number of seconds to wait before sending the next probe.
Units can be set to Centiseconds using packetIntervalUnits for Cfm TwoWay Delay and Two Way SLM tests on CPM3 7x50 devices
type=int default=1 minimum=1 maximum=10 units=seconds Displayed(tab/group)=Packet Interval (Test Parameters/Execution Details) |
| packetSize |
The size of the packets to send.
type=int default=40 minimum=40 maximum=9786 units=octets |
| packetTimeout |
Specifies the number of seconds to wait for the
response of a sent probe.
type=int default=5 minimum=1 maximum=10 units=seconds Displayed(tab/group)=Probe Timeout (Test Parameters/Execution Details) |
| packetsToSend |
The number of probes to send.
type=int default=1 minimum=1 maximum=100 Displayed(tab/group)=Number of Test Probes (Test Parameters/Execution Details) |
| testFailureThreshold |
The Test Failure Threshold parameter specifies
the number of test failures that occur before an
NE sends a trap about the test failure. The range
is 0 to 15. The default is 1.
type=int default=1 minimum=0 maximum=15 Displayed(tab/group)=Test Failure Threshold (Results Configuration) |
| trapGenerationPolicy |
Specifies when the node sends traps while executing the
test.
type=sas.PingTrapGenerationPolicy default=testCompletion Displayed(tab/group)=Trap Generation (Results Configuration) |
| Properties inherited from sas.AbstractTest |
|---|
| administrativeState, description, displayedName, failures, globalId, id, lastRunResult, runs, weight |
| Properties inherited from ManagedObject |
|---|
| actionMask, children-Set, deploymentState, isFaultSquelched, name, objectFullName, selfAlarmed |
| Methods inherited from sas.Test |
|---|
| adhocExecuteAndWait, executeAndWait, setNeSchedulableAdminState |
| Methods inherited from sas.AbstractTest |
|---|
| execute, stop |