| Overview | Package | Class | Deprecated | Help |
| Properties | |
|---|---|
| assurance |
type=sas.TestAdminState access=read-only default=disabled |
| maxHistoryRows |
>
The maximum number of rows allowed in the node's
probe result table. The node will remove the oldest entry
in the table to allow the addition of a new history
row.
A value of 0 for this object disables creation of
tmnxOamPingHistoryTable entries.
DEPRECATED: 8.0 R5 - OBSOLETE: Never Supported type=long access=read-only default=50 |
| packetFailureThreshold |
The Packet Failure Threshold parameter specifies the number
of times a probe can fail before the test fails.
The parameter has no effect if the value is higher than the
parameter value. The range is 0 to 15. The default is 1.
type=int access=read-only default=1 Displayed(tab/group)=Probe Failure Threshold (Results Configuration) |
| packetInterval |
Specifies the number of seconds to wait before sending the next probe.
Units can be set to Centiseconds using packetIntervalUnits for Cfm TwoWay Delay and Two Way SLM tests on CPM3 7x50 devices
type=int access=read-only default=1 Displayed(tab/group)=Packet Interval (Test Parameters/Execution Details) |
| packetSize |
The size of the packets to send.
type=int access=read-only default=40 |
| packetTimeout |
Specifies the number of seconds to wait for the
response of a sent probe.
type=int access=read-only default=5 Displayed(tab/group)=Probe Timeout (Test Parameters/Execution Details) |
| packetsToSend |
The number of probes to send.
type=int access=read-only default=1 Displayed(tab/group)=Number of Test Probes (Test Parameters/Execution Details) |
| testFailureThreshold |
The Test Failure Threshold parameter specifies
the number of test failures that occur before an
NE sends a trap about the test failure. The range
is 0 to 15. The default is 1.
type=int access=read-only default=1 Displayed(tab/group)=Test Failure Threshold (Results Configuration) |
| trapGenerationPolicy |
Specifies when the node sends traps while executing the
test.
type=sas.PingTrapGenerationPolicy access=read-only default=testCompletion Displayed(tab/group)=Trap Generation (Results Configuration) |
| Overridden Properties | |
|---|---|
| id | The identifier for the STM test. |
| Properties inherited from sas.AbstractTest |
|---|
| administrativeState, description, displayedName, failures, globalId, id, lastRunResult, runs, weight |
| Properties inherited from ManagedObject |
|---|
| actionMask, children-Set, deploymentState, isFaultSquelched, name, objectFullName, selfAlarmed |
| Methods inherited from sas.AbstractTest |
|---|
| execute, stop |