| Overview | Package | Class | Deprecated | Help |
| Properties | |
|---|---|
| authenticateOnDhcp |
Specifies the administrative state of DHCP-triggered authentication for the UE. While the
value of the object tmnxWlanGwVlanAuthOnDhcp is equal to 'enabled', the system will start
the authentication procedure upon receiving DHCP messages coming from unknown UE.
type=wlangw.AuthenticateOnDhcpType default=disabled Displayed(tab/group)=Authenticate On DHCP |
| authenticationHoldTimeHour |
Specifies the number of hours portion for the configured time to remember this auth.
type=int default=0 minimum=0 maximum=1 Displayed(tab/group)=Hours (/ISA RADIUS Authentication/Hold Time) |
| authenticationHoldTimeMinute |
Specifies the number of minutes portion for the configured time to remember this auth.
type=int default=0 minimum=0 maximum=59 Displayed(tab/group)=Minutes (/ISA RADIUS Authentication/Hold Time) |
| authenticationHoldTimeSecond |
Specifies the number of seconds portion for the configured time to remember this auth.
type=int default=5 minimum=0 maximum=59 Displayed(tab/group)=Seconds (/ISA RADIUS Authentication/Hold Time) |
| authenticationPolicyPointer |
Specifies the identifier of the authentication policy for migrant UE. The
authentication procedure is triggered by any Layer 3 packet other than a DHCP
message. An entry with the same name must exist in the
TIMETRA-RADIUS-MIB:::tmnxRadIsaPlcyTable.
type=Pointer default= Displayed(tab/group)=Auth Policy (/ISA RADIUS Authentication) |
| authenticationVlanMismatchTo |
Specifies the timeout for the radius proxy cache if a packet is received with a non-matching VLAN tag.
The timeout will be the minimum of this value and the currently remaining proxy cache timeout value.
type=long default=0 minimum=0 maximum=60 units=seconds Displayed(tab/group)=VLAN Mismatch Timeout (/Track Mobility) |
| dataTriggeredUeCreation |
Specifies the administrative state of data-triggered authentication for the UE.
While the value of the object tmnxWlanGwVlanDataTrigg is equal to 'enabled',
the system will start the authentication procedure upon receiving Layer 3 messages
coming from unknown UE.
type=wlangw.DataTriggeredType default=disabled Displayed(tab/group)=Data Triggered User Equipment Creation |
| dhcpActiveLeaseTimeHour |
Specifies the number of hours portion for the configured time to remember this authentication.
type=int default=0 minimum=0 maximum=1 Displayed(tab/group)=Hours (DHCP/IP Address Lease Time (Active State)) |
| dhcpActiveLeaseTimeMinute |
Specifies the number of minutes portion for the configured time to remember this authentication.
type=int default=10 minimum=0 maximum=59 Displayed(tab/group)=Minutes (DHCP/IP Address Lease Time (Active State)) |
| dhcpActiveLeaseTimeSecond |
Specifies the number of seconds portion for the configured time to remember this authentication.
type=int default=0 minimum=0 maximum=59 Displayed(tab/group)=Seconds (DHCP/IP Address Lease Time (Active State)) |
| dhcpInitialLeaseTimeHour |
Specifies the number of hours portion for the configured time to remember this auth.
type=int default=0 minimum=0 maximum=1 Displayed(tab/group)=Hours (DHCP/IP Address Lease Time (Initial State)) |
| dhcpInitialLeaseTimeMinute |
Specifies the number of minutes portion for the configured time to remember this auth.
type=int default=10 minimum=0 maximum=59 Displayed(tab/group)=Minutes (DHCP/IP Address Lease Time (Initial State)) |
| dhcpInitialLeaseTimeSecond |
Specifies the number of seconds portion for the configured time to remember this auth.
type=int default=0 minimum=0 maximum=59 Displayed(tab/group)=Seconds (DHCP/IP Address Lease Time (Initial State)) |
| dhcpL2AwareIpAddress |
Specifies the IP address to be given to the migrant User Equipment as 'yiaddr'
in DHCP OFFER and DHCP ACK messages. The same IP address can be given to
multiple UE because the user traffic is tunneled and this WLAN Gateway is layer-2-aware.
The virtual router instance corresponding to the service with ID 'svcId' must
have a row in the TIMETRA-NAT-MIB::tmnxNatL2AwAddrTable, such that the value
of tmnxWlanGwVlanMigAddr matches that address prefix but is not equal to the
value of TIMETRA-NAT-MIB::tmnxNatL2AwAddr.
type=InetAddress default=0.0.0.0 Displayed(tab/group)=L2 Aware IP Address (DHCP) |
| dhcpL2AwareIpAddressType |
Specifies the type of address stored in migAddr.
type=rtr.InetAddressType default=ipv4 |
| dhcpPrimaryDnsAddress |
Specifies the address of the primary DNS server to be given to the migrant
User Equipment in Option 6 of DHCP OFFER and DHCP ACK messages.
type=InetAddress default=0.0.0.0 Displayed(tab/group)=Primary DNS Server (DHCP) |
| dhcpPrimaryDnsAddressType |
Specifies the address type of migDns1Addr.
type=rtr.InetAddressType default=ipv4 |
| dhcpPrimaryNbnsAddress |
Specifies the address of the primary NBNS server to be given to the migrant
User Equipment in Option 44 of DHCP OFFER and DHCP ACK messages.
type=InetAddress default=0.0.0.0 Displayed(tab/group)=Primary NBNS Server (DHCP) |
| dhcpPrimaryNbnsAddressType |
Specifies the address type of migNb1Addr.
type=rtr.InetAddressType default=ipv4 |
| dhcpSecondaryDnsAddress |
Specifies the address of the secondary DNS server to be given to
the migrant User Equipment in Option 6 of DHCP OFFER and DHCP ACK messages.
type=InetAddress default=0.0.0.0 Displayed(tab/group)=Secondary DNS Server (DHCP) |
| dhcpSecondaryDnsAddressType |
Specifies the address type of migDns2Addr.
type=rtr.InetAddressType default=ipv4 |
| dhcpSecondaryNbnsAddress |
Specifies the address of the secondary NBNS server to be given to the migrant
User Equipment in Option 44 of DHCP OFFER and DHCP ACK messages.
type=InetAddress default=0.0.0.0 Displayed(tab/group)=Secondary NBNS Server (DHCP) |
| dhcpSecondaryNbnsAddressType |
Specifies the address type of migNb2Addr.
type=rtr.InetAddressType default=ipv4 |
| dhcpShutdown |
Specifies the administrative state of the DHCP protocol distributed on the
ISA cards for the matching migrant UE. While the value of the object
tmnxWlanGwVlanMigDhcp is equal to 'enabled', the distributed DHCP will reply
to DHCP Request messages coming from UE without a corresponding subscriber
known to this system.
type=wlangw.MigDhcpStatus default=disabled Displayed(tab/group)=Administrative State (DHCP) |
| end |
Specifies the end VLAN tag of this range.
type=long access=read-create minimum=0 maximum=4096 Mandatory on create Displayed(tab/group)=End VLAN Tag |
| httpRedirectPolicyPointer |
Specifies the identifier of the HTTP redirect policy for migrant UE. HTTP
redirect is triggered per subscriber during the authentication phase, by the
presence of certain vendor- specific attributes in the RADIUS Access-Accept
message (Alc-Wifi-Portal-Redirect or Alc-Wifi-Portal-Url). A row with the same
name must exist in the TIMETRA-SUBSCRIBER-MGMT-MIB::tmnxSubHttpRdrPlcyTable.
type=Pointer default= Displayed(tab/group)=Http Redirect |
| id |
The ifIndex ID of the parent group interface.
type=long access=read-create Mandatory on create |
| idleTimeoutAction |
Specifies the action to be performed when the idle-timeout timer goes off.
Idle-timeout is activated by RADIUS and is on by default for SLAAC.
type=wlangw.IdleTimeoutActions default=remove Displayed(tab/group)=Idle Timeout Action |
| l2AwareIpAddFromPool |
Specifies when the l2-aware IP address should be allocated from a pool.
If this parameter is specified instead of an IPv4 address, a unique address will be allocated for each UE.
The pool used is managed by the dhcpv4-nat pool manager configured under the same subscriber-interface.
type=boolean default=false Displayed(tab/group)=From Pool (DHCP) |
| l2RetailAdminState |
Specifies the administrative state of the Layer 2 Offload Service.
type=wlangw.OffloadAdminState default=disabled Displayed(tab/group)=L2 Retail Administrative State (/L2 Retail) |
| l2RetailDescription |
Specifies the user provided description of the layer 2 service.
type=string default= minimum=0 maximum=80 Displayed(tab/group)=L2 Retail Description (/L2 Retail) |
| l2RetailServiceId |
Specifies the id of the layer 2 service associated with this range.
type=long access=read-only default=0 |
| l2RetailServicePointer |
Specifies the identifier of the layer 2 service associated with this range. All traffic in
this vlan range will terminate in the associated layer 2 service instead of the parent
service of this group interface.
type=string default= Displayed(tab/group)=L2 Retail Service (/L2 Retail) |
| natPolicyPointer |
Specifies the identifier of the NAT policy for migrant UE. Layer-2-Aware NAT
hosts are temporarily created if UE are authenticated by a web portal. A row
with the same name must exist in the TIMETRA-NAT-MIB::tmnxNatPlcyTable.
type=Pointer default= Displayed(tab/group)=NAT |
| radiusProxyMacFormat |
Specifies how a MAC address is represented by the RADIUS Proxy server.
The value of tmnxWlanGwVlanRadProxMacFmt is only relevant while also non-zero/non-empty
values for tmnxWlanGwVlanRadProxVrtr and tmnxWlanGwVlanRadProxSrv are specified.
Examples:
'ab:' for 00:0c:f1:99:85:b8 SROS style
'XY-' for 00-0C-F1-99-85-B8 IEEE canonical style
'mmmm.' for 0002.03aa.abff Cisco style.
type=string default=aa: minimum=2 maximum=5 Displayed(tab/group)=MAC Address Format (/Track Mobility) |
| radiusProxyRouterID |
Specifies the identifier of the virtual router instance of the RADIUS Proxy server.
The system can learn authentication information about UE that use a closed-SSID from
the RADIUS Proxy server. The value zero specifies that there is no RADIUS Proxy server
associated with this VLAN range for the purpose of migrant users. Non-zero/non-empty
values of tmnxWlanGwVlanRadProxVrtr and tmnxWlanGwVlanRadProxSrv must refer to a row
in the TIMETRA-RADIUS-MIB::tmnxRadProxSrvTable.
type=int access=read-only default=0 |
| radiusProxyServerName |
Specifies the identifier of the retail service associated with this range.
A nonzero value for this object must be specified.
type=string access=read-only default= |
| radiusProxyServerPointer |
Specifies the name of the RADIUS Proxy server. The system can learn authentication
information about UE that use a closed-SSID from the RADIUS Proxy server. The empty
string specifies that there is no RADIUS Proxy server associated with this VLAN range
for the purpose of migrant users. Non-zero/non-empty values of tmnxWlanGwVlanRadProxVrtr
and tmnxWlanGwVlanRadProxSrv must refer to a row in the TIMETRA-RADIUS-MIB::tmnxRadProxSrvTable.
type=Pointer default= Displayed(tab/group)=RADIUS Proxy Cache (/Track Mobility) |
| radiusProxyServiceId |
ID of the associated VPRN service.
type=long access=read-only default=0 |
| retSvcId |
Specifies the identifier of the retail service associated with this range.
A nonzero value for this object must be specified.
type=long access=read-only default=0 |
| retSvcSitePointer |
Pointer to the identifier of the retail service associated with this range.
type=Pointer default= Displayed(tab/group)=Retail Service |
| routerId |
type=int access=read-only default=1 minimum=1 maximum=10240 |
| serviceId |
The ID of the parent service object.
type=long access=read-create Mandatory on create |
| siteId |
The IP address of the node.
type=string access=read-only default=0.0.0.0 maximum=64 Displayed(tab/group)=Site ID |
| start |
Specifies the start VLAN tag of this range.
type=long access=read-create minimum=0 maximum=4096 Mandatory on create Displayed(tab/group)=Start VLAN Tag |
| wlangw.WlanGwVlanBrgConfiguration-Set |
type=Children-Set |
| wlangw.WlanGwVlanCrossConnect-Set |
type=Children-Set |
| wlangw.WlanGwVlanDhcp6-Set |
type=Children-Set |
| wlangw.WlanGwVlanDsm-Set |
type=Children-Set |
| wlangw.WlanGwVlanLanExt-Set |
type=Children-Set |
| wlangw.WlanGwVlanSlaac-Set |
type=Children-Set |
| Properties inherited from ManagedObject |
|---|
| actionMask, children-Set, deploymentState, isFaultSquelched, name, objectFullName, selfAlarmed |
| Supported Network Elements | |
|---|---|
| 7750 SR |
Supported from 10.0.R2 until 15.0.R1
|
| Product Specifics | |
| 7750 SR 20.0 | |
| 7750 SR 21.0 | |
| 7750 SR 22.0 | |
| 7750 SR 23.0 | |
| 7750 SR 24.0 | |
| 7750 SR 25.0 | |